Trend Micro Home Network Security is flashing red

You notice the LED light of your Home Network Security Station keeps blinking red.

Why did this happen?

Your Home Network Security Station is either initializing or performing an update.

What should I do next?

Check the condition of your Home Network Security Station

Analyze if your Trend Micro Home Network Security Station is in good physical condition.

1. Check if its physical components are intact.

   

   

2. Ensure it is turned ON:
   1. Connect the adapter to the outlet and the Station.
   2. Make sure power on the outlet is turned ON.
   3. Change outlets to ensure power is ON.
3. Make sure you have a stable Internet connection:
   1. Disconnect your Home Network Security from the router.
   2. Check if the Internet line is connected to the router's WAN port.
      1. If there is no Internet connection:
         • Reboot your router.
         • Check the network status from your Internet Service Provider.
         • Check your router settings.
      2. If you can connect to the Internet, reconnect your Home Network Security Station to the router.
4. Check the connection between the router and the Station:
   1. Use the Ethernet cable provided to connect the Home Network Security Station to any available LAN ports of your router.

   2. Check if the two LED lights of the LAN port are turned on. LED lights should look like this:

      

      • One port should be blinking green.
      • The other port should be steady green or yellow.
   3. If the LED lights do not light up as mentioned, move the Ethernet cable to another router LAN port.
      Once the LED lights become normal, your Home Network Security Station should be connected to the network.

Wait depending on the frequency of the LED light

Wait for the specified amount of time depending on the frequency of the LED.

• For SLOW blinking red light, wait for about an hour for the Station to perform the update.
• For FAST blinking red light, wait for about 5 minutes for the Station to initialize.

If the station LED is still blinking red after the specified time, contact Trend Micro Support for assistance.